- #2004 mustang sequential tail lights install#
- #2004 mustang sequential tail lights driver#
#2004 mustang sequential tail lights install#
Your drivers side module install is the same as what you have just accomplished, with one minor change. Secure with zip-ties or Electrical tape and re-assemble tail lens to car. Module can be tucked into various positions behind the tail lens. Re-connect any loose light sockets to lens and be sure to tape all connections very well. This should be the last connection needed for this side of your car. Take the black wire coming from the tail light module and crimp it in the other end of the butt connector. Twist them together and crimp them into one end of a butt connector. Locate 元 sockets black wire from the GND cavity. (Previously cut 元 orange/blue “Major” wire) Attach your red wire from your tail light module to 元. Attach the orange wire from the tail light module to the L2 socket orange/blue “Major” wire. (labeled “Major”) Gently pull back to make sure that your terminal is securly fastened into the light socket and them re-seat your connector weather seal. Take your needle nose pliers and firmly insert the blade connector into the empty slot in the tail light bulb socket. Take the blue wire with the pre-soldered blade connector and slip it through the hole you just made in the weather seal. Poke a hole into the seal to allow for the third blue wire to be installed. #2004 mustang sequential tail lights driver#
Remove L1 socket from the tail lens and take a pocket screw driver to pry out the blue weather seal from the bottom of the connector.Grab one tail light module take the blue wire, without the spade terminal, and crimp it to the two orange with blue stripped wires that are coming from the harness. Twist the two wire that are coming from the harness together.Locate the Orange with blue stripe wire labeled MAJOR on the connector for L2 and 元, cut and strip. Notice that we have the inside light (grey plastic) labeled L1 the middle L2 and the outside 元.Use a towel under the light to avoid scratching bumper. Notice the locations of the four thumb screws.
Open your trunk and remove the Passenger rear tail light carpet/cover by loosening the cargo net thumb screws.
0 kommentar(er)
